Current Revision posted to RAM | STAAD | ADINA Wiki by Payel on 7/21/2022 11:07:00 PM
| Applies To | |||
| Product(s): | STAAD.Pro | ||
| Version(s): | All | ||
| Environment: | N/A | ||
| Area: | Analysis | ||
| Subarea: | Miscellaneous Analysis Solutions | ||
| Original Author: | Bentley Technical Support Group | ||
This page contain solutions to miscellaneous analysis related issues
- My hand calculations do not match the displacements being reported by STAAD.Pro
- Lifting Analysis
- I defined a composite deck and I am getting the following warning during analysis ***WARNING: MEMBER 1 HAS COMPOSITE PROPERTY ASSIGNED TO IT AND HENCE THE MATERIAL CONSTANTS ARE SET AS THOSE OF STEEL. CURRENT SPECIFICATION IS IGNORED EXCEPT DAMPING RATIO
- Base plate connection for a tube column
- Unable to load Bentley.LicLib.dll.Error:126.the specified module could not be found
- Changing units for existing input data in STAAD.Pro
- Copying connection templates
- Error "LoadLibrary failed with error 126: The specified module could not be found"
- STAAD.Pro model with connection data in it is not opening in STAAD.Pro SS6 ( 20.07.11.70 )
- Unable to activate RSS Feed connection message
- Unable to cast 'STAAD.Pro' COM object to 'OpenSTAAD' object
- [[** WARNING ** A SOFT MATERIAL WITH (1.0 / 1.526E+01) TIMES THE STIFFNESS OF CONCRETE ENTERED. PLEASE CHECK.]]
- [[What is the SET NL command]]
- [[***Error*** Modulus of Elasticity Missing For Element]]
- *** NOTE: CAPACITY FOR MAXIMUM # 266 LOAD CASES IS ASSIGNED FOR PLATE LOAD
- [[**ERROR** DEPENDENT NODE xx IS BEING DEFINED AS DEPENDENT TO CONTROL NODE yy WAS PREVIOUSLY A DEPENDENT TO A PRIOR CONTROL]]
- STAAD.Pro does not use the multiple processor
Tags: Miscellaneous Analysis Solutions