| Applies To | STAAD.Pro V8i | ||
| Product(s): | STAAD.Pro V8i, Select Series 6 | ||
| Version(s): | 20.07.10.41 and later | ||
| Environment: | All | ||
| Area: | STAAD.Pro Wiki | ||
| Subarea: | Licensing | ||
| Original Author: | Payel Sasmal | ||
Problem Description
I am accidently using STAAD.Pro Advanced Analysis Engine, STAAD.beava (Bridge Codes), STAAD Planwin and RAM Connection and I’m getting invoice for the usage. Can these be deactivated within STAAD.Pro?
Solution
To avoid using STAAD.Pro Advanced Analysis Engine, STAAD.beava and Building Planner (STAAD Planwin) follow the steps as mentioned below.
For Connect Edition:
On the STAAD.pro CONNECT Edition Open screen, in the lower right corner, make sure that the check boxes are unchecked if you do not want to utilize any of the additional modules.
For V8i Version:
- Start STAAD.Pro, in the License Configuration, uncheck the boxes next to Advanced Analysis Engine, STAAD.beava and Building Planner as shown here.
To avoid using the RAM Connection license, follow the steps as mentioned below.
- To avoid using the RAM Connection license along with STAAD.Pro, you have to make sure that the check box "Use RAM Connection Product License" should be always unchecked as shown here. In case, you are planning to use it, you will have to check back the box.
STAAD .Pro CONNECT Edition
On the STAAD.pro CONNECT Edition Open screen, in the lower right corner, make sure that the RAM Connection box is unchecked if you do not want to utilize a RAM Connection License.
See Also
Tips for Using RAM Connection within STAAD.Pro [TN].
Other language sources