Current Revision posted to RAM | STAAD Wiki by Sye on 3/10/2017 1:44:23 AM
Applies To | |||
Product: | STAAD.Pro | ||
First Affected Version: | 20.07.11.82 | ||
Found in Version: | 20.07.11.82 | ||
Released in Version: | |||
Environment: | All | ||
Area: | Modeling | ||
Subarea: | N/A | ||
Issue #: | 665038 |
Problem Description
The COMPRESSION ONLY attribute is being removed from the ELASTIC MAT/PLATE MAT supports when saving using the GUI.
Steps to Reproduce
- Open a file with ELASTIC or PLATE MAT support with the words PRINT COMPRESSION at the end.
- Save the file using the graphic user interface or do a Save As
- Note that the word COMPRESSION is deleted from the end of the command line.
Before Saving :
SUPPORTS
…
403 TO 433 ELASTIC MAT DIRECT YONLY SUBGRADE 12000 PRINT COMPRESSION
After saving the file using the GUI
SUPPORTS
…
403 TO 433 ELASTIC MAT DIRECT YONLY SUBGRADE 12000 PRINT
Workaround
It has been observed that if the PRINT command is not there, this problem does not happen. So as a temporary workaround please remove the PRINT command as shown next
SUPPORTS
…
403 TO 433 ELASTIC MAT DIRECT YONLY SUBGRADE 12000 COMPRESSION
Saving the file using the GUI or doing a Save As should work fine now.
Solution
Will be addressed in the STAAD.Pro Connect Edition expected in summer of 2017
See Also
Tags: plate mat, 665038, 20.07.11.82, elastic mat, COMPRESSSION, known issue